Initial support in v1.0.132

cantcu_linkg4x_integration.pdf

cantcu_link_can_frames.zip

• Adjustable CAN Speed
• Pre-made CAN Streams
• Cut/Blip based on CAN request

CANTCU CAN3 is connected to desired CAN on Link ECU.

To achieve a somewhat realistic torque estimation, the ECU VE (fuel) table needs to be tuned and show real-world VE-values. For this torque estimation we use a Torque Factor. The torque factor is generated from engine running values taken from a single point of running (usually maximum measured torque on a dyno run). The values needed for calculation are listed below.

• Maximum Engine Torque (Nm)
• Manifold Absolute Pressure, MAP (kPa)
• Volumetric Efficiency, VE, Fuel Table (%)

Entering these values in the calculation window will generate a torque factor, which will be used as a baseline for torque calculations in the CANTCU.

Example of a calculated torque factor