Site Tools


cantcu:integrations:motecm800

Motec M800

Initial support in v1.0.135

cantcu_motecm800.pdf

Features

  • Adjustable CAN ID
  • Pre-made CAN Streams
  • Cut/Blip through CANTCU Digital Outputs

Connection

CANTCU CAN3 is connected to CAN on Motec M800.

Torque Factor (CANTCU)

To achieve a somewhat realistic torque estimation, we use a Torque Factor. The torque factor is generated from engine running values taken from a single point of running (usually maximum measured torque on a dyno run). The values needed for calculation are listed below.

  • Maximum Engine Torque (Nm)
  • Manifold Absolute Pressure, MAP (kPa)
  • Max. Efficiency %, Fuel Table

Entering these values in the calculation window will generate a torque factor, which will be used as a baseline for torque calculations in the CANTCU.

Example of a calculated torque factor