Initial support in v1.0.131

Custom CAN selectable (in v1.0.135) for the GPRP package if CAN-stream out of MoTeC doesn't match default GPRP template.

cantcu_motec_integration.pdf

• Cuts and blips 0/1 triggers through CAN

CANTCU CAN3 is connected to MoTeC.

To achieve a somewhat realistic torque estimation, the VE (fuel) table needs to be tuned to show real-world VE values. For this torque estimation we use a Torque Factor. The torque factor is generated from engine running values taken from a single point of running (usually maximum measured torque on a dyno run). The values needed for calculation are listed below.

• Maximum Engine Torque (Nm)
• Manifold Absolute Pressure, MAP (kPa)
• Volumetric Efficiency, VE, Fuel Table (%)

Entering these values in the calculation window will generate a torque factor, which will be used as a baseline for torque calculations in the CANTCU.

Example of a calculated torque factor